Error codes for Bosch Tankless Water Heater
Bosch is a brand of appliances from Robert Bosch GmbH. It is one of the most reputable companies in the German and United States. The company has been manufacturing dishwashers, ranges, and freezers for over a century. This makes it one of the most experienced manufacturers of home appliances in the country.
The company has a long history of providing great products and services to its customers. Since its establishment, Bosch has been creating and designing a variety of products that will provide you with the best services and performance. Bosch is known for providing a wide range of products, including refrigerators, dishwashers, ranges, and more. The company is also committed to creating superior products that will help you maintain the comfort level in your home or office.
However, there are also some common issues that homeowners have with their Bosch water heater. These issues can lead to dangerous situations and even expensive repairs. The purpose of this article is to provide a comprehensive guide on how to identify these common issues so that you can be able to solve them quickly and effectively. Let’s check out some of the common problems and their possible solutions.
Connect with the Expert via email, text or phone. Include photos, documents, and more. Get step-by-step instructions from verified Tech Support Specialists.
Error code A2: There is a problem with the flue gas limiter
The temperatures of the flue gases are too high, and they are above 230 f. It is important that you check for any gas leaks near the gas combustion chamber and heat exchanger. Check that the limiter is operating and that all the wires are correctly connected to the control board and the limiter. It is located in the top-right corner of the unit.
Error code A3: Wire harness fault
Measure the resistance on the wire harness that you are using. It must be between 115 and 120 ohms.
Error code A4: Temperature sensor for backflow
Check the temperature sensor connection of the backflow sensor, because it may be damaged or short circuited. Below the heat exchanger and the ignition electrodes, you can locate the coil.
Error code A7: Fault in the temperature sensor at the outlet
The outlet temperature sensor should be triggered when the unit is operated at minus 36 f, or when the unit is operated at above 210 f in a situation when it is overheated due to the limescale deposits. Check the sensors and the wiring. You may need to flush the unit to remove the mineral build-up.
Error code A9: Fault of the outlet temperature sensor
Another error code that can be reported by the outlet temperature sensor, but this time the sensor is not sensing the expected output temperature. This is not an error code. Instead, it is a flashing status message that is intended to help you check the wiring. You should also check the gas pressure, because it might be too low. The voltage is too low, and the unit might not have enough grounding.
Connect with the Expert via email, text or phone. Include photos, documents, and more. Get step-by-step instructions from verified Tech Support Specialists.
Error code C6: Slow-spinning fan
The primary fan spins slowly while the water heater is running. Check the wiring connections between the fan and the control board. There must be a voltage of 120 vac and the element must be properly grounded.
