Error codes for Electrolux Oven

Electrolux is a leading manufacturer of household appliances. This company was founded some time ago and has been producing appliances for some years. It is one of the most popular brands in the world and offers several high-quality products for every type of home. It has designed many innovative products that have changed the way people use their ovens every day.

The Electrolux Oven is one of the most advanced ovens that are available today. It features an innovative design that provides superior performance. It comes with an easy-to-use control panel that allows you to adjust your preferences easily and quickly. This helps you to get the perfect clean every time you use it without any trouble or hassle. The best part about this oven is that it can fit into almost any type of space since it is compact and easy to install.

However, there are also some common issues that homeowners have with their Electrolux Oven editions that can lead to inconvenient situations and even expensive repairs. The purpose of this article is to provide a comprehensive guide on how to identify these common issues so that you can be able to solve them quickly and effectively. Let’s check out some of the common problems and their possible solutions.

F10

The controller has sensed that there is a risk of a runaway oven. It is possible that the relay has been shorted, and the RTD sensor probe may have gone bad. Check the probe on the RTD sensor and replace it if necessary. If your oven is overheating, disconnect the power. If the oven does not overheat when the power is reapplied, replace the relay board and/or display board.

F11

Shorted key: An alarm system will be activated if a key is pressed for a long time. That will be considered a shorted key alarm, and it will end all oven activity. Press the appropriate key to clear the error message. If there is a fault again, replace the keyboard (touch panel). If the problem persists, you should replace the display board.

F13

The internal checksum of control might have become corrupted. Press the appropriate key to clear the error message. Disconnect the power, wait 30 seconds, and reapply. If the fault returns after power-up, replace the display board.

F14

Misconnected keyboard cables. Verify that there is a connection between the display board and the touch panel (2 ribbon cables). Make sure that the cables are properly connected at both ends of the cable. If all the cables are good, then replace the touch panel. If the problem persists, you should replace the display board.

F15

This time, the controller self-check failed. Verify that the relay board receives voltage from J4 pin 1 and 3 between 120VAC. Verify that the wiring is connected between J2 on the relay board and p16 on the display board. If the wiring and the supply of 120VAC is good, replace the display board. If the problem persists, you should replace the relay board.

(Visited 52 times, 3 visits today)

Comments

mood_bad
  • No comments yet.
  • Add a comment