Error codes for Speed Queen Washer

Speed Queen is a manufacturer of a wide range of home appliances, including washers and dryers. Speed Queen offers a variety of different models of washers and dryers, each one offering different features and capabilities.

Washers and dryers are a common type of appliance that is used to wash and dry clothes. Washers and dryers are often equipped with features that allow you to easily clean your clothes, including cycle settings that allow you to quickly remove dirt and stains from your clothes.

However, there are some reasons washers and dryers can cause errors. Error codes can be very frustrating with some of the Speed Queen washers and dryers. They can cause a number of different problems. This article will describe some of the common error codes that are associated with Speed Queen washers and dryers, as well as provide some tips on how to fix them.

Tech Support 24/7
Ask a Tech Specialist Online

Connect with the Expert via email, text or phone. Include photos, documents, and more. Get step-by-step instructions from verified Tech Support Specialists.

Er FL

This code will appear if the washer does not reach its full capacity after 30 minutes during a wash or rinse cycle.

Make sure all hot and cold water outlets are turned on. Check that the fill hoses are not bent or kinked. Cleaning the screen that is located in the water mixing valve or the filter screen that is located on the faucet end of the fill hoses allows you to easily clean your clothes while the machine is in use. If the machine is stuck in this code, simply unplug it for 15 seconds and try again.

Er 5L

Er 5L will appear after running a wash cycle for a minute, or until the Power/Cancel keypad is pressed. It indicates that the detergent is not completely dissolved.

Laundry load may be too full. You should use a detergent that is high efficiency and has low sudsing. If using non-HE detergent. Do not use more than the recommended amount of detergent. Use only one-half of the recommended amount of detergent that your detergent manufacturer recommends.

Er ub

This code is displayed when the load is not balanced during the wash cycle. Washing clothes with an unbalanced load may limit the spin speed of the washer.

Tech Support 24/7
Ask a Tech Specialist Online

Connect with the Expert via email, text or phone. Include photos, documents, and more. Get step-by-step instructions from verified Tech Support Specialists.

Use load sizes that are balanced. Usually, error codes will display when it detects that the door has not been locked properly, but it is usually possible to open the door and clear the error code by pressing the Power/Cancel keypad or by opening the front panel.

Er.dl

This code means that the door is not locked properly. Make sure the door is shut completely when you try to start a wash cycle. Sometimes the machine will display an error code that you need to clear. Simply open the door or unplug the machine to clear the code. If this code continues to appear, contact Speed Queen customer service.

Er nF

If the washer is not filled up to the recommended level of water. No water level has changed in 5 minutes since the last filling, and no other water level has changed at all.

(Visited 63 times, 1 visits today)

Comments

mood_bad
  • No comments yet.
  • Add a comment