Electrolux is widely known for being a home appliances manufacturer that is based in Sweden. The company was founded in the year 1919 and it is one of the most popular home appliances manufacturers in the world. Electrolux offers a variety of different products such as refrigerators, ovens, ranges, cooktops and other household appliances.
The company also offers water filtration systems and dishwashers. These products are available online or through retail stores in different countries around the world.
On this page, you will find more information about the most common causes and most relevant solutions for the Washer & Dryer error 'E71'. Do you need help straight away? Visit our support page.
The Electrolux documentation indicates that error code 'E71' is caused by the following problem: "Washing NTC sensor faulty (short- circuited or open) Wiring faulty; Washing NTC sensor faulty; PCB faulty".
Do you think there is another cause for this error? Let others know in the comments.
We've created a list of solutions which you can follow if you want to solve this Washer & Dryer problem yourself. Do you need more help? Visit our support page if you need professional support with Washer & Dryer right away.
But Electrolux isn't without problems. One common error code that is associated with Electrolux is E71. This error occurs when you try to use your Electrolux appliance and it fails to function properly. The problem can be caused by a defective part or it can be caused by a power supply issue.
E71 is an indication that your outlet thermostat or wiring has failed, but it may also be a sign that a control panel is not properly functioning. There's likely an exposed circuit in the temperature sensor circuit while the wash cycle is ongoing. If this occurs, replace the main PCB. As a result, the wiring has gone bad.
Faulty wiring, broken wires, or a damaged wire could cause the problem. The reason is that there's a short circuit in the wiring and it causes an interruption of power to occur during the wash cycle. The faulty wiring may also be caused by a broken fuse or some other electrical device within your washer and dryer.
What you need to do is to inspect the wiring harnesses, check the fuses and then replace them if necessary. In addition to that, you need to clean the connectors and try to re-install the wiring harnesses. You should also use some silicon grease on all the terminals of your electrical devices so that they don't corrode over time.
The temperature sensor could also be faulty. If the sensor is not properly working, then you need to replace it. In addition to that, the control panel could also be damaged or it could have an issue with the thermal cutout switch. You should clean and inspect the switches so that they don't get damaged over time.
Check the resistance of the thermal cutout switch. If it is below a certain level, then you need to replace it or readjust it, though this can be tricky if you’re not a professional. In addition to that, if the sensor temperature is above the specified limit, then there's likely an issue with your thermostat or wiring harnesses.
If all else fails, you may need to replace the PCB or the main board entirely. When replacing any part of your washer or dryer, make sure that you have a copy of your owner's manual with you. It is important because it contains instructions on how to perform repairs and replacements on your appliances. Make sure that you follow these instructions carefully because even if you follow them properly, there are still some things that can go wrong during repair or replacement procedures.